15
When shipped from the factory, the tuning
mode is set to CH: chromatic.
2 Use the UP or DOWN button to select the
desired tuning mode.
CH: Chromatic. The note names are shown at
semitone (half step) intervals.
GT: Standard tuning for a guitar
(7B, 6E, 5A, 4D, 3G, 2B, 1E).
BS: Standard tuning for a bass
(LB, 4E, 3A, 2D, 1G, HC).
OD: Open D tuning for a guitar
(6D, 5A, 4D, 3F#, 2A, 1D).
OE: Open E tuning for a guitar
(6E, 5B, 4E, 3G#, 2B, 1E).
OG: Open G tuning for a guitar
(6D, 5G, 4D, 3G, 2B, 1D).
OA: Open A tuning for a guitar
(6E, 5A, 4E, 3A, 2C#, 1E).
DA: DADGAD tuning for a guitar
(6D, 5A, 4D, 3G, 2A, 1D).
P1–P5: Tuning programs you’ve created. You
can create up to five tuning programs. (☞p.16
“Creating a Tuning Program”).
If you decide to cancel your choice, press
the TUNER ON/OFF switch or press the
INPUT SELECT switch to change between
A and B.
3 Press the STORE button.
The INPUT SELECT indicator will blink. If
the A and B settings are identical, the A and B
indicators will blink. If the A and B settings
differ, the indicator selected by the INPUT
SELECT switch will blink.
4 Use the UP button, DOWN button, or
INPUT SELECT switch to select the internal
memory in which you want to store the
setting.
5 Press the STORE button once again.
The tuning mode setting will be stored in the
internal memory you specified, and the
pitchblack+ will return to the tuning state.
When you press the STORE button, the
calibration, tuning mode, flat tuning, and
display mode settings will all be saved at
the same time (☞p.14).
To Next Page
Loading...
Need help?
General
