Korg pitchblack+ User Manual

7
Installing the battery
1 Open the lid of the battery compartment
located on the bottom of the unit.
2 Attach a battery to the battery connector.
Make sure that the battery is oriented in the
correct polarity.
3 Fit the battery into the battery compartment
and close the lid.
When the battery nears the end of its life, the
TUNER ON/OFF indicator will blink. Please
install a new battery as soon as possible.
The included battery is provided so that
you can verify that the unit is operating
correctly; its lifespan may be shorter than
normal.
Restoring the factory settings
Here’s how to return the pitchblack+ to the
factory settings.
1 Connect a cable to the INPUT A or INPUT B
jack; the pitchblack+ will be powered-on.
2 While holding down the UP button and
DOWN button, press the TUNER ON/OFF
switch.
The tuner will turn off, and the following
settings will return to their factory-set state.
Calibration: 440 Hz (40)
Tuning mode: Chromatic (CH)
Flat tuning: 0
Display mode: Focus (F1)
Temperament program: 0 cent for all notes

Korg pitchblack+ Specifications

General

Type	Pedal Tuner
Calibration Range	436 - 445 Hz
Detection Accuracy	+/- 0.1 cent
Inputs	1 x 1/4" (Guitar/Bass)
Outputs	1/4" (Bypass)
Power Supply	9V DC (center negative) or Battery
Accessories	9V Battery
Tuning Range	E0 (20.60 Hz) - C8 (4186 Hz)