Korg pitchblack+ User Manual

9
INPUT A & INPUT B jacks
Connect the instrument(s) to be tuned to these
jacks.
If your instruments are connected to both
INPUT A and INPUT B, use the INPUT SELECT
switch to choose the instrument you want to
tune. The INPUT SELECT indicator shows the
instrument whose input jack is selected.
You can specify the calibration, tuning mode,
flat tuning, and display mode independently
for each input jack. For example you can
specify regular tuning for the instrument
connected to INPUT A, and “open A” tuning
for the instrument connected to INPUT B.
INPUT B
INPUT A
Instrument 1
Instrument 2
A
Calibration, Tuning mode,
Flat tuning, Display mode
Calibration, Tuning mode,
Flat tuning, Display mode
B
If you connect just one instrument to either
INPUT A or INPUT B (not both), you can use
the INPUT SELECT switch to choose either A or
B settings (calibration, tuning mode, flat tuning,
display mode). The INPUT SELECT indicator
shows the settings you’ve selected.
For example if you’ve specified regular tuning
for A and flat tuning at a semitone lower for B,
you can use the setting A to perform in regular
tuning, and then switch to setting B and
perform in flat tuning.
INPUT SELECT
switch
INPUT A
Instrument
A
Calibration, Tuning mode,
Flat tuning, Display mode
Calibration, Tuning mode,
Flat tuning, Display mode
B
If instruments are connected to both INPUT
A and INPUT B, and you disconnect the
cable from the input jack currently selected
by the INPUT SELECT switch, the input
selection will automatically switch to the
other input jack.

Korg pitchblack+ Specifications

General

Type	Pedal Tuner
Calibration Range	436 - 445 Hz
Detection Accuracy	+/- 0.1 cent
Inputs	1 x 1/4" (Guitar/Bass)
Outputs	1/4" (Bypass)
Power Supply	9V DC (center negative) or Battery
Accessories	9V Battery
Tuning Range	E0 (20.60 Hz) - C8 (4186 Hz)