.
CREAT/NG
SOUNDS
You may now select any of the VCF parameters by press-
ing one of the Number buttons. For
exadple.
press
’
3
’
to
select
KBD
TRACK,
’
j
’
to
select EG
;NT,
and so on.
You may also press
’
8
’
to select the Chorus ON/OFF
Parameter. (Pressing
’
:
’
will
result in a blank VALUE
Display.)
I
press
BANK HOLD again to cancel the Bank Hold
fun0
tion and return to the normal two-digit
se/ectf~n
method.
To make any edited or newly created sound PERMANENT,
you must write it into one of the
64
Program Numbers in the
memory(
::
-SE).
The
memorlred
programs are protected by the
balterles.
and will not be erased when the power
swllch
I.?
turned
off. (See the MEMORY BACKUP section,
P.5.
for
lurther
information).
NOTE:
MEMORY WRITE PROCEDURE
1.
Set the Program Write switch on the rear panel to the
ENABLE oosition.
~-WRITE----
SEQUENCER
PROGRAM
ENABLE/DISABLE ENABLE/DISABLE
2.
Make a mental note of the current Program Number,
il
you want to write an edited version
“over”
the
original
program.
I
3.
Press the red WRITE button. The Program Number in
the Display will be replaced by a pair of flashing lines.
to show that you are in Wrile mode.
4.
Press the Number buttons
toselect
the Program Number
where you want to store the edited sound.
EXAMPLE:
To store
the
edlted
sound
In
Program Number
3’7,
press the Number Select buttons 3 and
then
‘7.
Afler button
’
3
’
Is
pressed, the
DISPLAY will show the following:
NOTE:
Al
fhispoinf
(before rhesecond
burron
ispi-ascd), the “old”
round in memory is
aill
unchanged.
ljyoupm~ed
lhe
wrong
numberfor
rhejirsr
digif (AND
AREABOUT
VJ
ERASE
THE WRONG PROGRAM):
l switch the rear panel Program Write switch
to
the
!DfSABLE position
l switch it back to the ENABLE position
. press the red WRITE bution again
l then press the correct Number buttons
(’
3
’
and then
I
t-1
s-l
The edited sound is now stored in Program Number
j”-:
To Next Page
Loading...
Need help?
General
