_
.
.
L,
rhe
po~aw
will
now
produce a
‘Yevel
hting”
test
tone
at the
TD
TAPE jack (a medium pilched
‘ooo”
sound).
Using this tone, adjust the Record Level (Volume) set-
ting on the tape recorder so that it is about 30 per cent
lower than the level at which the signal distorts.
l If the recorder has VU tape meters. adjust the record
level control to obtain a reading around
-5dB.
vu
Meter
When the recording level adjustment is completed,
release
the
PAUSE button lo begin recording.
(You
may
want to record a short verbal message
deicribing
the
program contents before you begin
recor$ng
lhe ac-
tual data.)
Press Ihe SAVE button to begin transferring the Pro-
gram and Sequencer data on the
Poiy-804
to
the tape
recorder.
L
p---“LRw”-CINCEL
1
PROG/PARA
PROGRAM
NO.
PmAMETER
HO.
“A,L”E
0
PROGRAM
NO.
PIRAMETER
HO.
YALUE
7.
After about 14 seconds, the DISPLAY will change from
SAVE to TAPE, and
you
should stop the tape recorder
(if you’re done making “safety” copies). All data has
now been recorded on the tape.
l To guard against accidental loss of your data, it’s a
good idea to repeat Step 6 several times to make
“safety” copies of your data. Leave a five-second gap
between recording so that you can find the beginn-
ing of each recording easily.
8.
Return the rear panel TAPE ENABLE/DISABLE switch
to the DISABLE position.
If you listen to a tape of recorded data. you will hear the follow-
ing tones:
Level sat tone (lower-pilched “ooo”)
4
Leader tone (high-pitched
“eee”)
+
Data tone (medium-pitched
“aaa”)
L
End tone (high-pitched %+a”)
*
Level set tone (lower-pitched “000”)
Leader toria
indicates Ihe beginning of the SAVE
operation.
oata tone
The actual digital data from the
Poly-800
Programmer and Sequencer.
End tone
indicates end of the SAVE operation.
The VERIFY procedure should always be used after SAVE
to make sure that the Program and Sequencer data
has
been
recorded properly. It Is also useful for determining the best
playback level to usa with your tape recorder
1.
Connect Poly-800 rear panel FROM TAPE jack to the tape
recorder output
j&k
(EARPHONE or LINE OUT). Set
FROM TAPE switch to HIGH (earphone) or LOW (line
out), according to,type of recorder output jack used.
-
To Next Page
Loading...
