Korg Poly-800 - Page 37

3.
4.
.
TAPE INTERFACE
-TAPE----G2
LOWfiH
SEC,
ENAB:I
Rewind the tape to a little before the recording starts, and
play it back.
3.
6. Start tape recorder playback. It will take about 14 seconds
to Verify the data. There are three possibilities:
.
1.
2.
The recorded data is GOOD (90 to step 7).
There is an ERROR, and either the recorded data
is bad or there is a level setting problem (90 to step 6).
There is no apparent change (go to step 9).
l Stop the tape (or press Pause) when you hear the begin-
ning of the leader tone.
Set the recorder Volume control to a medium level
(around 5). If tone controls are provided rfeble andlot
Bass). set them flat.
Set rear panel TAPE ENABLE/DISABLE switch to the
ENABLE position. The DISPLAY will show the following
message:
I
TAPE
ENABLE/DISABLE ‘I” LO
7. If the VERIFY operation was successful. the DISPLAY
will show (his message:
PROGRAM NO.
PARAMETER HO. VALUE
. Stop the tape recorder, and return the rear panel TAPE
ENABLE switch to the DISABLE position.
I
ENABLE/DISABLE ‘lo
TAPE-
LOV
I
-
8. If you got an Err (Error) indicalion. press the CANCEL
button. You will obtain the normal TAPE message on the
DISPLAY.
5. P&s the VERIFY button. The DISPLAY will show the
following:
02 02 02 b3 03 03
D& D,o o,or,o 0-O 0),00