*Repeat the VERIFY procedure using different tape
recorder Volume settings
(112
to 1 number at a time).
PROGRAM
NO.
PARAMETER
HO.
VALUE
YQU
may also try changing the selling of the FROM
TAPE “HIGH/LOW” switch.
-TAPE------1
-FROM1
SEC)
LOW/HIGH
ENABL
f
When you find settings
thal
work. write them down for
future
re1erence.
9.
If the “Verty” message is still displayed 15 seconds after
starting playback. either the recorder level is loo low
or
there is a problem with the cables.
-Press
the CANCEL button.
sel
the recorder Volume
somewhat higher, and repeat the VERIFY procedure
lrom
steo
2.
UPORTANT NOTES
YOU WILL NOT GET A “GOOD” MESSAGE IF THE TAPE
DATA IS DIFFERENT IN ANY WAY
FROM,THE
DATA IN
THE POLY-800, even if VERIFY has been performed pro-
perly and all
setrings
are fine. This is because the VERIFY
procedure checks to make sure that the Prqgram and Se-
quencer data on
Ihe
tape MATCHES the data in the
Pay-800 memoly.
!
I
THINGS TO TRY if you repeat the VER\FY procedure
several times and still do not get a
“GC@”
indication:
*
repeat
the SAVE procedure using
diffejent
recording
levels. When you find a level lhat works. WRITE IT
DOWN FOR FUTURE REFERENCE.
*
try
a
different. higher quality brand of tape.
*
make
sure
that
lhe heads of your tape recorder are clean
and demagnetized.
*
lry
a different tape recorder
*
check your batleries and AC adaptor. The Tape Inler-
face
may not work reliably with low balteries. with other
than
lhe recommended KORG AC adaptor, or at low line
voltages.
Both Program and Sequencer data is always recorded on the
tape. However, you can choose
the
data you want to LOAD
back into the
Poly-800:
l Program Data only
. Sequencer
Dam
only
*
80th Program and Sequencer Data
NOTE:
LOADING
doro
from tape ERASES the corresponding dalo
previously in
/he
Pa/y-800.
.
1.
Connect
Poly-800
rear panel FROM TAPE jack to the tape
recorder outpul jack (EARPHONE or LINE OUT). Set
FROM TAPE switch to HIGH (earphone) or LOW (line
oul). according lo type of recorder output jack used.
-TAPE-
LOW/HIGH
7
EN%
TAPE RECOROER OUTPUT JACK
HIGH/LOW
Line
oul
( AUX
)
LOW
Earphone HIGH
Headphone HIGH
2.
Rewind the
tape
to a little
belore
the recording
starts,
and
play it back.
.
Siop the lape (or press Pause) when you hear the
beginning
o!
the leader
tone.
3.
Select proper settings for the tape recorder Volume and
Tone controls and the rear panel FROM TAPE HIGH/LOW
switch. (Use settings that produced a
“Good”
indication
during VERIFY)
4.
Sel rear panel TAPE ENABLE/DISABLE switch to the
ENABLE position.
To Next Page
Loading...
