5.
Select
whelher
Program data. Sequencer
dafa
or both
will be loaded.
l
To LOAD Program data, set the
rear
panel
PROGRAM
WRITE switch to the ENABLE position.
l To LOAD Sequencer data, set the rear panel SE-
QUENCER WRITE switch to the ENABLE position.
. If you don’t want to LOAD Program data (or Sequencer
data), make sure that the appropriate WRITE switch
,ir
io3beDlS4EiLE
position.
6. Press the LOAD button:
,
-“-VEFw”-CAHCEL
,
PROGPARA
7.
Start tape recorder playback. It takes about 14 seconds
to LOAD data.
6.
If
lhe
LOAD operation was successful. the DISPLAY will
show this message:
l
Stop the tape recorder, and return rear panel TAPE and
WRITE swilches to the DISABLE position.
I
ENABLE,DlsAaLE
T
~-WRITE--,
PROGRAM
LE
ENABLEKJIswLE
/
I
-
-
--
9. If
you
gel a “Err” (Error) message, or if the DISPLAY
7
does”‘1 change at all after about 15 seconds, press the
CANCEL button and repeat the LOAD procedure
from
step 2; using different volume settings.
. Steps 6 and 9 of the VERIFY procedure offer further
suggestions that work just as well for LOADING data
into the
Poly-600.
.
NOTE
Afteryou hovefinished
u.Mq
rhe
Tape
Inlerface,
set
lhererrr
panel
TAPEswirch
to
rheDISABLEposirion (and
makesure
all
WRITE
swilches
are
also
se!
to
DISABLE).
You will
no!
be able to play
the
Poly-600
if the TAPE switch
is left in the ENABLE position.
I
TAPE-
ENABLE/DISABLE
‘lo
LO
To Next Page
Loading...
