2.Rear Pa
附
~ACV
⑨
ACcord
@
Hold/Trigger jack
⑦
Bypa
弱
jack
• Inpu
tJ
Output Section
の
Input
Whennothing is connected to Input jack B
,
the signal in‑
put of Unit Ais also connected to Unit B.
Also
,
whenlow level signals such as somemicrophones
,
are input directly
,
it maybeimpossible to raise volume to
appropriate levels. (In such cases it is necessary to use a
preamp.)
②
Feedback Input
Used for patching
・
The internal feedback loop is cancel‑
led whenthis input is used. Volume andphase of signals
connected to this input jack are controlled via the Feed‑
back Control
⑤
on the front panel.
③
E
作
ect Output
Effect sounds are output via this jack.Theoutput level is
fixed
,
and is not controlled by the E
付
ect Output Control
⑫
on the fr ont panel.
④
Direct Output
Direct sounds are output via this jack.Theoutput level is
fixed
,
and is not controlled by the Direct Output Control
([J)
on the front panel.
⑤
‑Mix Output
This provides amixed output of direct and reversed
phase effect sounds. Mixing level is controlled by!he
Direct Output Control andthe E
偽
ct Output Control
⑪ &
⑫
on the front panel.
@ 千
Mix Output
‑・・・・・
8
This provides amixed output of direct and in phase effect
sounds. Mixing le vel is controlled by the Direct Output
Control and the Effect Output Control
([J)
&⑫
on the
front panel.
,‑‑
‑‑Control Section
‑HOLD/TRIG‑ ‑‑BYPASS‑‑
B
A
B
A
⑧⑬⑬@
'‑GND
‑"・
GND
• Control Section
⑦
Bypass Jack
For control of the BYPASS function. Independent for
each uni
t.
Refer to page 7
,
Bypass Switch"
⑪
and
Bypass Indicator"
⑮
③
Hold/Trigger Jack
Usedas Hold control whenunits are used as norma1ldelay
machines. Phrase is held via footswitch control. Input
phrase is repeated as long as footswitch is held down
,
according to preset delay time. Used as Trigger Control
whenunits are used for sampling. Recording/Playback is
controlled via drum machine or footswitch(
l..
GND). Nor‑
mally open type footswitches
,
such as the PS‑1 or PS
・
2
昨lU
St be used.
⑦
ACCord Socket
Supplied ACcord is connected here