Output noise level ( 6 Steps )
misure to do with a Audio Analyzer, connect the single OUT to the input of the Audio Analyzer.
Out LEFT Noise Level Test (Step 1)
LED E. Piano1 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Out RIGHT Noise Level Test (Step 2)
LED E. Piano1 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Out LEFT Phone 1 Noise Level Test (Step 3)
LED E. Piano1 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Out RIGHT Phone 1 Noise Level Test (Step 4)
LED E. Piano1 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Out LEFT Phone 2 Noise Level Test (Step 5)
LED E. Piano1 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Out RIGHT Phone 2 Noise Level Test (Step 6)
LED E. Piano1 ON
In order to repeat this test press the button E.PIANO 1.
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
LED E. Piano2 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
LED E. Piano2 ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
OUT Test ( 4 Steps )
Left OUT 120Hz wave sound
LED Harpsi ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Right OUT 120Hz wave sound
LED Harpsi ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Left OUT 3000Hz wave sound
LED Harpsi ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Right OUT 3000Hz wave sound
LED Harpsi ON
The DEMO LED BLINKS waiting for the operator to press and go to next step of test
Dynamic Keyboard Test
LED Vibes ON
The operator acts on keyboard, from right to left, with a dynamic range between levels 40/90; in the case the pressing
sequence is correct AND the detected value is in the specified dynamic level, the sound related to preceding key is
switched off and a note related to present key pressed is activated.
If the sequence is wrong OR the dynamic is not correct WAIT UNTIL CORRECT SEQUENCE AND DYNAMIC.
In order to repeat this test press the button VIBES.
When the first on the left side is reached the DEMO LED starts blinking waiting for the operator to press it and go to
next step.
To Next Page
Loading...
