32 Chapter 5
2 On the SP-250, hold down the TRANSPOSE/FUNCTION button and press the
VIBES/GUITAR sound selection button. The LEDs of the TRANSPOSE/FUNC-
TION and VIBES/GUITAR buttons will blink, and the SP-250 will wait to receive
the data dump.
3 Set the data filer to send the sound setting data that were previously saved from the
SP-250. Please read the data filer owner’s manual for details on data transmission.
The SP-250 will receive the data.
When the data dump is finished, the SP-250 will return to the same status it was
before the data dump.
During a data dump operation, the SP-250 will not produce sound, and no other
function will work.
You may cancel a data dump operation before the data dump begins, by pressing the
TRANSPOSE/FUNCTION or VIBES/GUITAR button.
To Next Page
Loading...
