EasyManua.ls Logo

Korg Toneworks AX1500G - PEDAL Effect Block

Korg Toneworks AX1500G
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
4. Appendices
PEDAL effect block
These effect models let you use the expression pedal to control
the effect in realtime. They include a volume pedal, modulation-
type effects such as VOX WAHRING MOD, and ambience-
type effects such as HOLD DELAYSAMPLE&PLAY.
VOX WAHRING MOD cannot be used simultaneously
with the MODULATION effect block. Nor is it possible to
use HOLD DELAYSAMPLE&PLAY simultaneously with
the AMBIENCE effect block.
Volume
This is a volume pedal.
VOLUME “VOLUME”
Knob 5 LEVEL Adjust the minimum level for when the
pedal is in the full back position.
Pedal wah, Traveler, Talking pedal
These are wah (filter) effects that use the pedal to control the
frequency response.
If you use this effect in a program where the MODULA-
TION effect block is turned on, the MODULATION effect
block will automatically be turned off.
VOX WAH “WAH”
This simulates a vintage wah pedal. There are no adjustable
parameters. It is placed ahead of the DRIVE-AMP effect block.
TRAVELER “TRAVEL”
This is a low-pass filter type wah modeled after a vintage Korg
effect pedal.
Knob 1 ——— ————
Knob 2
FEEDBACK
Adjusts the peak amount of the filter.
Knob 3 ——— ————
Knob 4 ——— ————
Knob 5 LEVEL Adjusts the output level.
TALK “TALK”
This adds vocal type effects to your guitar.
Knob 1 TOP Select the vowel sound produced when
the pedal is fully forward.
Knob 2 CENTER Select the vowel sound produced when
the pedal is in the halfway position.
Knob 3 BOTTOM Select the vowel sound produced when
the pedal is fully backward.
* Vowel sounds — A, E, I, O, U
Chorus/Flanger
This is a chorus/flanger effect that uses the pedal to control the
mix amount of the effect.
If you use this effect in a program where the MODULA-
TION effect block is on, the MODULATION effect block
will automatically be turned off.
CHORUS/FLANGER “CH/FLAN”
Knob 1 TIME Adjusts delay time.
Knob 2
FEEDBACK
Adjusts amount of feedback
(delay repeats).
Knob 3 SPEED Adjusts pitch modulation speed.
Knob 4 DEPTH Adjusts pitch modulation depth.
U-Vibe
This simulates a vintage vibrato/rotary speaker simulator.
If you use this effect in a program where the MODULA-
TION effect block is on, the MODULATION effect block
will automatically be turned off.
U-VIBE “U-VIBE”
Knob 4 DEPTH Adjusts depth of the effect.
Knob 5 MODE 0:Mixes the original sound with the ef-
fected sound (Chorus mode)
1: Output only the effect sound
(Vibrato mode)
PEDAL
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
FEEDBACK/ BOTTOM/SPEED/ LEVEL/MIX/
TOP/TIME CENTER/REVERSE PITCH/TONE DEPTH/FINE POLARITY
VOLUME 0...10
VOX WAH ——
TRAVELER 0...10 0...10
TALK A, E, I, O, U A, E, I, O, U A, E, I, O, U
CHORUS/FLANGER 1...10 0...10 0.1...10 0...10
U-VIBE 0...10 1, 2
PITCH BEND 0...900[ms] 0...10 –24...24[x100
CENT
] –15...15[
CENT
] 0...10
RING MOD 1...10
HOLD DELAY 0[ms]...3[SEC] 0...10 1...10 0...10
TAP DELAY 0[ms]...3[SEC] 0...10 1...10 0...10
SAMPLE&PLAY 0.5...8[SEC] OFF, 1, 2...8, LP1, LP2 0...10

Related product manuals