TRITON EasyStart
3. Press [START/STOP] to begin recording Ä Press [START/STOP] again to stop recording. What could be easier?!
New! Alternate song method for copying Combis with Arps:
1. Choose any Combi with the [ARP ON/OFF] switch on (lit).
2. Create a new song
Ä Press the upper right corner drop-down menu and press “Copy from Combi” Ä Confirm [OK]
with [F8]
Ä Check both boxes “with Effects” and ”Auto Adjust Arp for Multi REC” ÄPress [OK]].
3. Press [START/STOP] to begin recording Ä Press [START/STOP] again to stop recording.
New! Swing quantize
1. Press [MENU] Ä Press [P5] [TrackEdit] Ä Select a Track to edit; select the first four measures as a region to edit (from
M:001 to End of M:004)
Ä
2. Press the upper right corner drop-down menu and select Quantize Ä Set Resolution to the 16
th
note icon Ä Press the
“Swing:” field, type or dial in a percentage, and press[OK].
Sampling mode
TRITON samples at 48kHz, 16-bit, in mono or stereo. With the provided 16 MB, the TRITON is capable of
recording samples of 174 seconds @ mono, or 87 seconds @ stereo. Fully expanded with SIMM modules to 64
MB, it allows about 11 ½ mono minutes or 5.8 stereo minutes of sampling! The correct SIMMS are 72-pin, non-
parity, EDO or Fast Page (FPM) DRAM SIMM, 60 ns (nanoseconds) or faster, 11 Bit Addressing.
Recording “one-shot” vocal samples
! Before proceeding clear the TRITON’s sample RAM by powering OFF, then ON.
1. Connect a microphone to the [AUDIO INPUT 1] jack on the rear panel, set the MIC/LINE switch to MIC, and set the
LEVEL control to the 12 o’clock position.
2. Press the [SAMPLING] key Ä Press the [Input Setup] tab ÄIn the Input 1 field, press the popup by XBUS(IFX) Select:
and choose L/R ÄSet Input 1 Pan: to “C064” with the DIAL or numeric keypad ÄIn the Recording Setup field, press
the Auto radio button, set the Threshold to –30 db, and set Pre Trigger REC: to 5ms with the DIAL or keypad.
3. Press the [Recording] tab and make sure that “MS” (Multisample) is set to “000:new MS____000” Ä Set both the
OrigKey and TopKey fields to a value of “C2”. The easiest way to set this is by holding down the [ENTER] key and
pressing the [C2] key on the keyboard.
ÄUnder the REC Sample Setup field, touch the popup by Sample Mode: X and
set to “L-Mono”.
4. Press the [Preference] tab and set the Zone Range to 1key with the DIAL or keypad .
5. Press the [Recording] tab ÄPress the [REC/WRITE] key to “arm” the sampler, and then speak into the microphone. If
“ADC Overload” flashes above the “level indicators”, lower the rear panel LEVEL control until this message no longer
flashes
Ä Press the [dB] fader in the Recording Level field and adjust with the DIAL while speaking into the mic. Set
this for a “hot” signal level, but watch and adjust if the display indicates, “CLIP”.
6. Press the [START/STOP] key and say the word, “Sampling” Ä Press [START/STOP] again to stop sampling, and then
press [CREATE]. Note that the “keyboard” display moves to the next key after you press “CREATE”.
6
To Next Page
Loading...
