TRITON Training Guide
38
Rename the edited Program, then write it:
31. Press the T Text Edit (T) button to the left of FingertipsGuitar. A text edit window appears. Press the
Clear button - the name field in the upper - left clears. Now press the Shift button, then press each text
box to rename the Program: BOB'S GUITAR., then press OK (if you make a mistake, and want to move
through the new name field and change characters, use the < > arrow boxes and the Delete button,
then re-insert the correct characters).
32. After you press OK, a Write Program dialog box appears. Leave the Category as it is. Press the
popup button to the left of B005 FingertipsGuitar, and a Write Destination menu appears. Note the
Bank tabs to the left of the center menu.
33. Press the Bank E tab, and in the center menu, press E003, then press OK - the dialog box appears
again, with the new destination Program Bank/Number highlighted.
34. Press OK, then press OK again - when prompted Are you sure? - to write the Program to the new
location.
Note: The E bank is normally reserved for Programs that use new user - samples, as you'll see in
the Sampling and Sequencing section that follows.
Work with the Master Effects:
1. Press the MENU key, then press P9: Edit - Master Effect. Press the Master FX tab in the lower - left of
the display. On this page, you'll see both Master effects (MFX1 and 2), the Send 1 and 2 chain box,
direction, signal and level settings, as well as the Return1 and 2 levels. The 3-band Master EQ Gain
settings are here as well.
To Next Page
Loading...
