TRITON Training Guide
46
Preference Tab:
9. Press the Preference tab and set the Zone Range to 1 key with the DIAL or Numeric keys. This setting
means that each new index you'll be creating in the multi-sample will be a half -step higher.
Recording Tab:
10. Press the Recording tab.
11. Press the REC/WRITE key to "arm" the sampler, and speak into the microphone. If "CLIP" flashes
above the indicators in the Recording Level [dB] field, press the 0.0 "fader" and lower the level
accordingly. If "ADC OVERLOAD" flashes above the indicators, the audio input level on the rear panel
has been set too high - lower it until the "ADC OVERLOAD" indicator no longer flashes.
Record the samples:
12. Press the START/STOP key and say the word "It's". Press START/STOP again to stop sampling, then
press Create (above the Recording Level indicators).
13. Press the START/STOP key and say the word "So". Press START/STOP again to stop sampling, then
press Create (above the Recording Level indicators).
14. Press the START/STOP key and say the word "Easy". Press START/STOP again to stop sampling,
then press Create (above the Recording Level indicators).
15. Press the START/STOP key and say the word "To". Press START/STOP again to stop sampling, then
press Create (above the Recording Level indicators).
16. Press the START/STOP key and say the word "Sample". Press START/STOP again to stop sampling,
then press Create (above the Recording Level indicators).
17. Press the START/STOP key and say the word "With". Press START/STOP again to stop sampling,
then press Create (above the Recording Level indicators).
18. Press the START/STOP key and say the word "TRITON". Press START/STOP again to stop sampling,
then press Create (above the Recording Level indicators). That's it!
19. Now play the keyboard - play each note (half - step) from C2 (Low-C) up to F#, and you'll hear the
words: "Its So Easy To Sample With TRITON".
Here's what happened:
You just created a new Multisample! You set the Orig and Top keys to the same key, as well as setting the
Zone Range to 1 key, and after you sampled a word and pressed Create, the TRITON automatically set the
Orig and Top keys - 1 key higher than the previous sample, ready for the next sample. When you finished,
your samples were mapped in half - steps across the keyboard! Like we said, it can't get any easier than this!
To Next Page
Loading...
