Korg TRITON pro - 9-2: Mfx 1; 9-3: Mfx 2; 9-4: Master EQ

28
▼ 9–1: Page Menu Command
9–1A: Copy Master Effect
This command lets you copy any desired effect settings from
Program, Combination, Song, Sampling, or Song Play
modes.
1 Select this command to open the following dialog box.
2 In “From,” select the copy source mode, bank, and num-
ber.
3 Select the effect that you wish to copy. If you select MFX
1 or 2, “Return” (return level) will be copied at the same
time. If you select Master EQ,” only the master EQ set-
tings will be copied. You can also copy from an insert
effect. If you check “All,” all settings of the master effects
and master EQ will be copied.
If you copy from an insert effect the result may not be
identical, due to differences in routing and level set-
tings.
4 Select the copy destination master effect.
5 To execute the Copy Master Effect command, press the
OK button. To cancel, press the Cancel button.
9–1B: Swap Master Effect
This command swaps (exchanges) the settings of MFX1 and
MFX2.
1 Select this command to open the dialog box.
2 To execute the Swap Master Effect command, press the
OK button. To cancel, press the Cancel button.
9–2: MFX 1
9–3: MFX 2
Make effect parameter settings for the MFX1 and 2 effects
that were selected in the Master FX tab (
☞p.155).
9–4: Master EQ
The master EQ is a three-band stereo EQ. It is used to adjust
the overall tonality of the sound immediately before the L/R
bus is output to the AUDIO OUTPUT (MAIN OUT) L/
MONO and R jacks (
☞p.207).
0–1A
9–1A
9–1B
9–1
0–1A