Quick Start
6
6. Turn knob [3] (EG-INTENSITY) to adjust filter EG intensity (the depth at which the filter EG
is applied).
Rotating the knob will affect the depth of the filter EG. Normally, rotating the knob toward
the left will make the filter EG apply less deeply, and rotating it toward the right will make
the filter EG apply more deeply. Since the filter EG will operate based on the cutoff frequency
of the filter, knobs [1] and [3] will work together to control the tonal changes produced by the
filter.
7. Turn knob [4] (EG-RELEASE) to adjust EG release times of the filter and amp. This will
determine the time from note-off until the sound disappears.
When you adjust the knob, the release times of the filter EG and the amp EG will change.
Normally, rotating the knob toward the left will shorten the release time, and rotating it
toward the right will lengthen the release time.
8. Press the REALTIME CONTROLS [SELECT] button to light the “B” LED located at the right
of the button.
In B-mode, effective functions for each of the preloaded programs and combinations are
assigned to the knobs. This lets you use the knobs to control volume, portamento time, pan,
filter and amp EG, pitch LFO, master effect send levels, and other parameters.
Turn each knob to hear the result.
Note: The B-mode functions for the REALTIME CONTROLS [1], [2], [3], and [4] knobs can be
viewed for Program mode in the 0: Play, Program page, and for Combination mode in the 0:
Play, Combination page.
To Next Page
Loading...
Need help?
General
