Kostal PIKO 7.0 User Manual

Homepage_Cover
Operating manual
PIKO inverter
3.0 - 20

Kostal PIKO 7.0 Specifications

General

Brand	Kostal
Model	PIKO 7.0
Category	Inverter
Language	English

Summary

1. General information

1.1 Proper use

Details intended use of the PIKO inverter and precautions against misuse.

5. Web server

5.1 The web server

Describes the web server interface for inverter configuration and data retrieval via a browser.

5.2 Using the web server

Explains computer network settings required to access the inverter's web server interface.

5.3 Connecting the inverter and computer

Details the process of physically connecting the inverter to a computer using an Ethernet cable.

6. System monitoring

6.1 Create connection between computer and inverter

Explains how to connect a computer to the inverter for configuration and data retrieval.

6.2 The log data

Details the types of data recorded by the inverter's data logger for system monitoring.

6.3 Retrieve, save and graphically represent log data

Guides on downloading, storing, and visualizing system log data for analysis.

10. Technical data

10.1 Technical data

Presents detailed electrical and mechanical specifications for PIKO inverter models in tables.

3. Installation

3.3 Installation

Details guidelines for selecting an appropriate installation site and mounting the inverter.

3.4 Electrical connection

Explains how to connect the inverter to the mains supply and other electrical components.

3.5 Connection of solar module

Guides on correctly connecting the PV modules (strings) to the inverter's DC inputs.

3.6 Connection of communication components

3.7 Initial commissioning

Outlines the step-by-step procedure for the initial setup and activation of the inverter.

4. Operation and operating the device

4.1 Switching on the inverter

4.2 Switching off the inverter

4.3 De-energising the inverter

Details critical safety steps for completely de-energizing the inverter before maintenance.

4.4 Control panel

4.8 The service menu

4.9 The energy management system in the inverter

4.10 Event codes

7. Active power control

7.1 Why active power control?

7.2 Limitation of the PV feed-in capacity

7.3 Activate power control with a ripple control receiver

Describes how to enable active power control using a ripple control signal receiver.

7.4 Install the ripple control receiver

Provides instructions for installing a ripple control receiver for active power control.

8. Self-consumption

8.1 Self-consumption overview

8.2 Electrical connection for self-consumption

Details the wiring diagram for connecting a load relay for self-consumption control.

8.3 Set up self-consumption control in the web server

Guides on configuring self-consumption control functions through the inverter's web server interface.

9. Maintenance

9.1 Maintenance and service

9.2 Fan cleaning

9.3 Update software (communication board)

9.4 Update software (inverter firmware)