12’X14’ assembly manual
x32
Parts Required:
X41
X43X42
X44
X45
X46
X47
X48
Snap Bracket (Part Z) to roof panel edges as shown in diagram.(with snaps facing upwards)
X41 x2 X42 x2 X43 x2 X44 x2 X45 x2 X46 x2
X47 x2 X48 x2
X2
page 22
H3 x1
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
1. Wearing protective gloves is recommended.
2.In order to avoid Z-clips (plastic brackets) from sliding off prior to assembly,
place double-sided adhesive tape (Part H3) to the down side (bottom) edge
of the roof panels where the Brackets (Part Z) are supposed to attach.
Tip:
Step 18: Snap Bracke
To Next Page
Loading...
