What to do if KRain KRX8 has no automatic start?
If your KRain Network Hardware has no automatic start, first check the fuse and power point if there are no lights on the controller. If the unit works manually, check your program setup and dial position. Ensure the dial is in the RUN position for regular automatic operation. The issue may be due to a setup error, the MAIN DIAL being in the OFF position, a blown fuse, or a power issue.
What to do if my KRain KRX8 fuse keeps blowing?
The 1 amp glass fuse protects the board from damage due to issues in the field wiring. If the fuse blows, inspect the wiring on each station for any damage. If the fuse continues to blow, disconnect all wires from the stations and reconnect them one by one to identify which station is causing the fault.
What to do if KRain Network Hardware KRX8 was connected is now not connecting after mounting in desired position?
If your KRX8 was connected but is now not connecting after mounting, it likely indicates a weak Wi-Fi signal. To resolve this, move your KRX8 and Wi-Fi router closer to each other.
What to do if KRain KRX8 single zone is not working?
If a single zone is not working, the cause may be a faulty solenoid coil or a break in the field wire. Check the solenoid coil (a good solenoid coil should read around 33? on a multi meter). Test the field cable and the common cable for continuity.
What to do if KRain KRX8 multiple zones watering at once?
If multiple zones are watering at once, the solenoids may be dirty. Clean and flush them to remove debris. Check the wiring and swap faulty valve wires on the controller terminal block with known working zones. If the same outputs are still locked on, please contact our Customer Service team. This issue can also be caused by a possible faulty driver triac, incorrect field wiring, or a broken or lost common wire in the field.
What to do if my KRain KRX8 rain sensor not working?
If the rain sensor is not working, especially for third-party sensors, it could be due to faulty wiring or the sensor itself. Check the rain sensor information on Holman Home and inspect the wiring on the sensor.
How to fix KRain Network Hardware KRX8 not connecting in AP MODE?
If your KRX8 is not connecting in AP MODE, ensure that mobile data is switched off.
What to do if there are no LED lights on my KRain Network Hardware?
If there are no LED lights on, it indicates that the unit is not receiving power. Check the power point and replace the fuse if necessary. The controller will not operate if there is an AC fault.
Why is my KRain Network Hardware KRX8 not connecting to Holman Home?
There could be several reasons why your KRX8 is not connecting to Holman Home. Here are some things to check: * Ensure your KRX8 is powered on. * Make sure your KRX8 and smartphone are within Wi-Fi range. * Verify that Bluetooth is turned on and permissions are approved for Holman Home. * Confirm that your Wi-Fi router and smartphone network functions are unblocked, as firewalls can block certain ports. * Check that your Wi-Fi network name (SSID) has been entered correctly, including spaces, and note that it is case-sensitive. * Confirm that your Wi-Fi network password has been entered correctly. * Ensure your KRX8 is connected to a 2.4GHz Wi-Fi network (not 5GHz), enable the broadcast, and do not allow the Wi-Fi network to be hidden. * Confirm your Wi-Fi router encryption...
General| Brand | KRain |
|---|---|
| Model | KRX8 |
| Category | Network Hardware |
| Language | English |
To Next Page