KRain KRX8 - Page 17

17 of 40
Installation
3. Set up the MANUAL
WATERING run time
for each ZONE
® This run time is used
when you press START
on-board the controller
for each ZONE
® This run time is
used in SCENE
AUTOMATION when
you switch a ZONE on
4. Set the MAINDIAL
position–for STARTS
to water, ensure it is
set to RUN, otherwise
ensure it is OFF
5. Set up any INPUTS
such as rain or humidity
sensors–refer to INPUTS
for more information
6. Set up either
TAP-TO-RUN or
AUTOMATIONS to enable
the WATERING DELAY
where appropriate
Setting up your KRX8 in Holman Home