To Next Page
C
Cindy SuttonSep 6, 2025
What to do if my KRAL CG is deflected?
- TTodd JonesSep 6, 2025
If your KRAL Water Pump is deflected, support the piping or loosen pipe connections and mount stress-free.
What to do if my KRAL CG is deflected?
If your KRAL Water Pump is deflected, support the piping or loosen pipe connections and mount stress-free.
What to do if there is advanced wear of rotating pump components in my KRAL Water Pump?
If there is advanced wear of rotating pump components in your KRAL Water Pump, check the screw set and housing and replace them if necessary.
What to do if my KRAL CG overflow valve leaks?
If your KRAL Water Pump overflow valve leaks, clean the overflow valve and reseat it if necessary.
What to do if my KRAL CG suction line is closed?
If the suction line of your KRAL Water Pump is closed, check any shut-off devices in the suction line and open them if they are closed.
What to do if my KRAL CG motor is running at the wrong voltage or frequency?
If your KRAL Water Pump motor is running at the wrong voltage or frequency: * Ensure that the motor voltage and frequency match the operating voltage. * Compare the speed of the motor with the pump rating plate. If the data do not match, adjust the speed of the motor.
What to do if my KRAL Water Pump has airlock or gas in the liquid?
If your KRAL Water Pump has an airlock or gas in the liquid: * Test the pipe system for air admission and replace parts if necessary. * Reduce the suction head. * Increase the feed pressure.
What to do if the viscosity of the pumped liquid is too low in my KRAL CG Water Pump?
If the viscosity of the pumped liquid is too low in your KRAL Water Pump, decrease the temperature of the liquid or increase the rotation speed.
What to do if the viscosity of the pumped liquid is too high in my KRAL Water Pump?
If the viscosity of the pumped liquid is too high in your KRAL Water Pump, increase the temperature of the liquid or reduce the rotation speed.
What to do if my KRAL CG's magnetic coupling is broken off?
If the magnetic coupling of your KRAL Water Pump is broken off: 1. Stop the pump immediately and restart it. 2. Avoid excessive differential pressures. 3. If it happens repeatedly, check whether the pump has gotten stuck.
What to do if my KRAL CG Water Pump suction capacity is reduced by inadequate wetting?
If the suction capacity of your KRAL Water Pump is reduced by inadequate wetting, fill the pump with liquid.
General| Series | CG Series |
|---|---|
| Type | Centrifugal Pump |
| Material | Cast iron, Stainless steel |
| Temperature Range | Up to 120 °C |
| Inlet Diameter | DN 32 - DN 100 |
