To Next Page
S
Shawn FloresAug 28, 2025
What to do if the differential pressure of my KRAL CG is too high?
- AAngela KeyAug 29, 2025
If the differential pressure of your KRAL Water Pump is too high, check the system and reduce the differential pressure.
What to do if the differential pressure of my KRAL CG is too high?
If the differential pressure of your KRAL Water Pump is too high, check the system and reduce the differential pressure.
What to do if the level of liquid in the intake container of my KRAL CG Water Pump is too low?
If the level of liquid in the intake container of your KRAL Water Pump is too low, top up the pumped liquid.
What to do if my KRAL CG Water Pump suction line or shaft seal leaks?
If the suction line or shaft seal of your KRAL Water Pump is leaking, check the suction line or shaft seal for leaks, paying particular attention to leakage at valves and connection points. Replace parts if necessary.
What to do if my KRAL CG suction valve or line is obstructed?
If the suction valve or line of your KRAL Water Pump is obstructed, check the suction valve and line to ensure they are clear.
What to do if my KRAL CG Water Pump has incorrect pump direction of rotation?
If your KRAL Water Pump has an incorrect direction of rotation, make the electrical connection such that the direction of pump rotation matches that of the arrow on the flange cover.
What to do if my KRAL CG filter or strainer is soiled?
If the filter or strainer of your KRAL Water Pump is soiled, clean the filter or strainer.
General| Series | CG Series |
|---|---|
| Type | Centrifugal Pump |
| Material | Cast iron, Stainless steel |
| Temperature Range | Up to 120 °C |
| Inlet Diameter | DN 32 - DN 100 |
