Kramer FC-70R - FC-70 R Commands

8
FC-70R - FC-70R Commands
6 FC-70R Commands
Every command must start with #.
When a connection is established, send the first command "#ANATF 1" to reset the
translator.
Every KB command to an HSL device starts with one of the following commands:
#ANATR – R CTRL | R CTRL
#ANATL – L CTRL | L CTRL
#ANATR F11 – R CTRL | R CTRL | F11 |
#ANATL F11 – L CTRL | L CTRL | F11 |
This is followed by a letter or a number in HEX based on the below table:
Command
Hex Code
#define KEY_NONE
00
#define KEY_A
04
#define KEY_B
05
#define KEY_C
06
#define KEY_D
07
#define KEY_E
08
#define KEY_F
09
#define KEY_G
0A
#define KEY_H
0B
#define KEY_I
0C
#define KEY_J
0D
#define KEY_K
0E
#define KEY_L
0F
#define KEY_M
10
#define KEY_N
11
#define KEY_O
12
#define KEY_P
13
#define KEY_Q
14
#define KEY_R
15
#define KEY_S
16
#define KEY_T
17
#define KEY_U
18
#define KEY_V
19
#define KEY_W
1A
#define KEY_X
1B
#define KEY_Y
1C