Operate KIT-400 via:
• Front panel buttons
• Remotely, by RS-232 serial
commands transmitted by a
touch screen system, PC, or
other serial controller
• Embedded web pages via the
Ethernet
• Remote control switches.
• Room Automation Panel.
RS-232 Control / Protocol 3000
Example: (Set the Audio out volume level to 75): #AUD-LVL 1,1,75
Default Ethernet Parameters
Operating via the remote control switches
Momentarily connect the desired pin to the GND pin to select an input:
Short press – Select the input.
Long press – Adjust the VGA phase shift.
Select the IN 4 input on KIT-400R.
Increase the analog audio output level.
Short press – Increase volume by one step.
Long Press – Increase the volume from 0 to 100% in
10 seconds.
Decrease the analog audio output level.
Short press – Decrease volume by one step.
Long Press – Decrease the volume from 100% to 0
in 10 seconds.
One button toggles between display on and display
off (instead of using two separate buttons for on and
off). Alternatively, using the KIT-400R OSD,
configure toggling display on and off according to
whether a switch is open or closed (for example,
when using an occupancy sensor).
Operating via Room Automation Panel
Control KIT-400 via any of Kramer’s touch panels which include the Kramer Aware app (for example, KT-1010).
To operate KIT-400 via room automation
panel:
1. Open Kramer Aware app on your
touch panel.
2. Enter KIT-400R IP address.
The KIT-400 default control screen
appears.
You can change the default control screen
configuration via the KIT-400 embedded
web pages.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
To Previous Page
Loading...
