Kramer RC-63DLN - Page 12

RC-63DLN – Overview
9
3.2.3 Accessing the RC-63DLN Reset to Default Button
To reset to the factory default settings, disconnect the power and then connect it
while pressing the RESET TO DEFAULT button (using a small screwdriver). The
unit will power up and load its memory with the factory default KNET ID auxiliary
setting (ID=2).
This operation should be carried out by authorized Kramer technical
personnel or by a qualified system integrator.
You can access the button by removing the volume control knob,
unscrewing the 4 screws on the front panel and removing it.
i