Kramer TP-102HD - System Configuration

Configuring a 1:2 XGA / HD-to-Twisted Pair DA System
7
5 Configuring a 1:2 XGA / HD-to-Twisted Pair DA System
You can use the TP-102HD XGA / HD Line Transmitter / DA with two
TP-120 XGA Line Receiver units
1
to configure a 1:2 XGA / HD-to-Twisted
Pair DA system. This will let you transmit a computer graphics / HD signal to
two displays via long line CAT5 UTP cabling.
To connect the TP-102HD to two TP-120 units, as the example in Figure 5
illustrates, do the following:
1. On the TP-102HD, connect the XGA / HD source (for example, a computer
graphics / HD source) to the XGA IN HD15F connector, and connect the line
output RJ-45 connector
2
:
 OUT 1 connector to the LINE IN RJ-45 connector on the first TP-120
 OUT 2 connector to the LINE IN RJ-45 connector on the second TP-120
2. On the two TP-120 units, connect the:
 XGA OUT HD15F connector of the first TP-120 unit to the XGA / HD
acceptor (for example, Display 1)
 XGA OUT HD15F connector of the second TP-120 unit to the XGA /
HD acceptor (for example, Display 2)
3. On each of the three Kramer TOOLS, connect the 12V DC power adapter
to the power socket and connect the adapter to the mains electricity.
The signal from the XGA source is transmitted via the two CAT5 cables,
decoded and converted at the each of the XGA OUT HD15F connectors
to the XGA acceptors.
4. On the TP-120 units, if necessary:
 Set the H SYNC and V SYNC switches
3
on the underside
 Adjust
4
the video output signal level and/or cable compensation
equalization level
5. On the TP-102HD, if necessary, set the VS and HS switches
5
on the
underside
1 Refer to the separate user manual: PT-110, PT-120, TP-120, WP-110, which can be downloaded from the Internet at this
URL: http://www.kramerelectronics.com
2 Via UTP cabling (with a range of more than 300ft (>100m)). For details of how to wire a CAT5 LINE IN / LINE OUT
RJ-45 connector, see section 5.1
3 By default, both switches are set down (for negative V SYNC and H SYNC polarity)
4 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
5 By default, both switches are set to the left (to NORMAL) to retain the V SYNC and H SYNC polarity