Kramer TP-205A

Configuring the TP-205A
9
5.2 Looping the TP-205A
You can loop two
1
TP-205A units to add further output signals to the system,
as illustrated in the example in Figure 4. In this example:
1. Connect the XGA LOOP 15-PIN HD connector of the first TP-205A to the
XGA IN 15-PIN HD connector of the second TP-205A.
2. Connect the S/PDIF LOOP RCA connector of the first TP-205A to the S/PDIF
LOOP RCA connector of the second TP-205A.
3. Connect the GND and LOOP right terminal block connectors of the first
TP-205A to the GND and IN left terminal block connectors of the second
TP-205A.
4. Connect the LINE OUTPUT RJ-45 connectors on each TP-205A unit, to the
LINE IN RJ-45 connectors of various receivers, as illustrated in Figure 4.
5. On each TP-205A unit, connect the 12V DC power adapter to the power socket
and connect the adapter to the mains electricity.
TP-46
TP-122
TP-122
TP-122
TP-50
TP-50
TP-50
TP-46
TP-46
TP-120
TP-120
TP-124
Computer
Graphics
Source
Figure 4: Looping the TP-205A
1 The number of TP-205A units that can be looped depends upon the quality of the input signal that you require and the
distance between the machines. We do not recommend cascading more than five TP-205A units