5.1 Connecting the VM-50AN as a Balanced Stereo 1:5 Audio Distributor
To connect
1
and operate the VM-50AN as a balanced stereo 1:5 audio
distributor, as the example in Figure 2 illustrates, do the following
2
:
1. Connect the balanced stereo audio source to the INPUT terminal block
connector.
2. Connect up to five balanced stereo audio acceptors to the OUT terminal
block connectors.
3. Connect the 12V DC power adapter to the power socket, connect the
adapter to the mains electricity, and then turn on the power switch.
4. Release the BAL/UNBAL INPUT MODE button to select balanced stereo
audio operation.
5. Adjust
3
the right and/or left output signal level, if required.
Figure 2: Connecting the VM-50AN as a Balanced Stereo 1:5 Audio Distributor
1 Switch OFF the power on each device before connecting it to your VM-50AN. After connecting your VM-50AN, switch on
its power and then switch on the power on each device
2 You do not have to connect all the outputs
3 Insert a screwdriver into the hole and carefully rotate it, to trim the level
To Next Page
Loading...
Need help?
General
