Kramer VM-50AN User Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using Your VM-50AN 1:5 Audio Distributor
6
5.2 Connecting the VM-50AN as an Unbalanced Stereo 1:5 Audio
Distributor
To connect
1
the VM-50AN as an unbalanced stereo 1:5 audio distributor, as
the example in Figure 3 illustrates, do the following
2
:
1. Connect the unbalanced stereo audio source (for example, a PC sound
card) to the INPUT mini 3.5mm socket.
2. Connect up to five unbalanced stereo audio acceptors to the OUT mini
3.5mm sockets.
3. Connect the 12V DC power adapter to the power socket, connect the
adapter to the mains electricity, and then turn on the power switch.
4. Push in the BAL/UNBAL INPUT MODE button to select unbalanced
stereo audio operation.
5. Adjust
3
the right and/or left output signal level, if required.
Figure 3: Connecting the VM-50AN as an Unbalanced Stereo 1:5 Audio Distributor
1 Switch OFF the power on each device before connecting it to your VM-50AN. After connecting your VM-50AN, switch on
its power and then switch on the power on each device
2 You do not have to connect all the outputs
3 Insert a screwdriver into the hole and carefully rotate it, to trim the level

Kramer VM-50AN Specifications

General

Brand	Kramer
Model	VM-50AN
Category	Media Converter
Language	English