3
1 At any resolution (for example, UXGA)
2 Allowing selection of KR-ISPlNormal technology by internal jumpers. Note that both the Hs (horizontal sync) jumper and
the Vs (vertical sync) jumper MUST be setidentically
3 Available from Kramer Electronics on our Web site
To achieve the best performance:
• Use only good quality connection
cables
to avoid interference,
deterioration in signal quality due to poor matching, and elevated
noise levels (often associated with low quality cables)
• Avoid interference from neighboring electrical appliances that
may adversely influence signal quality and position your Kramer
VP-200AK away from moisture, excessive sunlight and dust
TheKramerTOOLSVP-200AK is a 1:2distributionamplifierforUXGA(and
higher)resolutionsignals,as wellasunbalancedstereoaudiosignalsand/or
balancedstereoaudiosignals.
In particular, the VP-200AK 1:2 UXGA/ Audio DA:
• Accepts one computer graphics input', provides correct buffering and
isolation, and then distributes the signal to two identical outputs on
high-density I5-pin HD connectors
• Accepts an unbalanced stereo audio input, and simultaneously
outputs two unbalanced stereo audio outputs on mini-plug
connectors, and two balanced stereo audio outputs on terminal block
connectors
• With its video bandwidth exceeding 500MHz, ensures transparent
operation at high-resolution graphics modes such as UUXGA
(I600xI200)
• Accepts TTL syncs" and provides ID bit control internally, as well as
separate controls for audio output level and UXGA equalization
• Features KR-ISP™ advanced sync processing that ensures
compatibility with a wide range of computers (even if the sync level
is too low) by restoring the sync signal waveform to achieve a sharp,
stable image
• Is 5V DC fed
3 Overview
Overview
To Next Page
Loading...
Need help?
General
