Kranzle K 1050 TS T Original Operating Manual

36 37
Functional details
Please note - important
Lack of water
Lack of water occurs more often than you
probably believe. The more powerful a
high-cleaner is the greater is the danger
that a lack of water occurs. If there is only
an insucient amount of water available,
cavitation (water-gas mixture) arises
inside the pump, which is normally noticed
too late or even not at all. The pump will
be destroyed. Please check the available
quantity of water by filling a bucket with
liter scale for one minute .
A minimum water quantity of 7.5 l/min is needed for the high pressure cleaner
to operate.
If the metered quantity of water is too small, you have to use a dierent
water connection, guaranteeing the necessary output.
Lack of water leads to an accelerated wear of the joints (guarantee void).
Never let the pump run dry for more than 20 seconds.
Water supply
Please pay attention to the regulations of your waterworks com-
pany! In accordance with DIN EN 61770, the machine may not be
directly connected to the public drinking water supply lines. A brief
connection however is permissible according to DVGW (German
Association for Gas and Water Aairs) if a non-return valve with
tube ventilator (Kränzle order no. 41.016 4) is built into the water
supply. Once the water has passed through the non-return valve it
is no longer considered as drinking water. Also indirect connection
to the public drinking water supply lines is permissible by way of
free emission in accordance with EN 61 770; e.g. by using a reservoir
with a float valve. Direct connection to a non-drinking water supply
line is permissible.
Functional details
Insucient quantity of electricity
If there are too many collectors in your
proximity connected to the network at the
same time, the available voltage and the
current intensity may decline. Consequently
the motor of the high pressure cleaner does
not start or even blows.
The power supply may also be insucient if
the power cable is too long or too thin.
If extension cables are too long, this may
lead to a voltage drop causing malfunctions
or start-up diculties.
KRÄNZLE 1050 TS T: 230 Volt/ 50 Hz
Check the line fusing and have the voltage and the available current
intensity checked by an expert in case of uncertainty.
Electrical connection
The machine is supplied with a 5 meter electrical power cable with plug. The mains
plug must be fitted to a standard grounded socket with a 30mA residual current
operated device. The socket must be protected with a 16A fuse on the mains side.
When using an extension cable, this must have an earthed lead which is properly
connected to the socket. The conductors in the extension cable must have a
minimum cross section of 1.5 mm². Plug connections must be of a spray-proof de-
sign, and may not be located on a wet floor. With extension cables of more than 10
m the minimum cross section must be 2.5 mm! When using a cable drum, always
keep the cable wound as far as possible.
GB

Kranzle K 1050 TS T Specifications

General

Brand	Kranzle
Model	K 1050 TS T
Category	Pressure Washer
Language	English