Kranzle K 1050 P User Manual

Read and conform safety instructions before use!
Keep instructions in a safe place for later use and
pass them on to any future user.
www.kraenzle.com
Original operating manual
High pressure cleaner
K 1050 P
- GB -

Kranzle K 1050 P Specifications

General

Hose Length	10 m
Working Pressure	105 bar
Voltage	230 V
Max. Inlet Water Temperature	60 °C
Flow Rate	10 l/min
Water Flow Rate	10 l/min
Pump Type	Axial
Motor Speed	2800 rpm

Summary

Technical Data

Explanatory Symbols Guide

General Rules for Operation

Safety Precautions

Personal Protective Equipment (PPE) and Prohibitions

Requirements for PPE and specific actions that are forbidden during operation.

Prohibited Safety Actions

User and Machine Placement Restrictions

Electrical Safety and Water Jet Avoidance

Mandates electrical safety and avoiding water jets near electrical installations.

Prohibitions: Water Jets, Cables, and Hoses

Details prohibitions on directing water jets at people/animals and handling cables/hoses.

Functional Details and Operation

Water Supply Requirements

Putting the High Pressure Cleaner into Operation

Machine Placement and Environmental Restrictions

Connecting Accessories

Electrical Connection and Start-up

Steps for electrical connection, machine bleeding, and initial start-up.

Shutting Down the High Pressure Cleaner

Powering Down and Disconnecting

Sequence for switching off the cleaner, releasing pressure, and disconnecting power/water.

Troubleshooting and Minor Repairs

No Water or Irregular Jet Issues

Safety Reminder Before Repair Work

Critical safety reminder to disconnect power before any repair.

Intermittent Cycling and Leakage Issues

Troubleshooting intermittent machine operation caused by leaks or valve defects.

Non-Return Valve Issues

Troubleshooting intermittent machine operation caused by a defective non-return valve.

Wiring Diagram

Oil Change Procedure