20
Small repairs - do it yourself!
No or very little water from the lance.
Proceeding:
Switch o the cleaner. Pull plug from
the socket. Operate trigger gun with
safety catch several times to decrease the
pressure.
Unscrew trigger gun and lance first,
then rinse high pressure gun to remove
possible soiling.
Check water inlet filter for soiling.
If the problem still exists, take wire (paper
clip) and push through nozzle opening.
If cleaning by means of a wire is not
successful, replace lance
.
Problem:
No water from nozzle although motor is running.
Cause:
Most likely the nozzle is blocked.
Pull plug from socket prior to starting any repair work!
To Next Page
Loading...
