Kranzle quadro 11/140 TST - Small Repairs

Small repairs
The nozzle is blocked!
No water but the gauge shows full pressure !
remove the lance and clean
the nozzle.
Using the at spray lance you
only have to clean the front
nozzle.
Straighten a paper
clip and clean the
nozzle.
Insert pointed object
into the hole and pull
the cap back!
Check visually whether the
nozzle is clean.
Now it works as well
as before.
20
Rinse the hose
through rst.
You should now have a
powerful stream of
water,
but if you
only get a few
drops of water
from the
lance