44
Inspections
The machine must be inspected according to the “Guidelines for Liquid Spray Devices” at
least once every 12 months by a qualied person, to ensure that continued safe operation
is guarateed.
The results of the inspection are to be recorded in writing.
This may be done in any form. (see pages 46-47)
Accident prevention
The machine is designed for accidents to be impossible if used correctly.
The operator is to be notied of the risk of injury from hot machine parts and the high
pressure water jet. The “Guidelines for Liquid Spray Devices” must be complied with. (see
pages 15 - 17).
Check the oil level at the oil dip stick prior to each use (see also page 11).
(Ensure horizontal position!)
Oil change:
The rst oil change should be carried out
after approximately 50 operating hours,
then every year or after 1000 operating
hours. If the oil turns grey or white, you must
change the oil of your high pressure pump
in any case. Open the oil discharge screw
at the bottom of the device over a collec-
tion resevoir. Ensure a horizontal position
to drain the oil completely. The oil is to be
caught in the reservoir and disposed of in
an approved manner.
New oil: 0,8 l
Motor oil: Castrol 10 W-60 SAE halfsyn-
thetic oil
General rules
Oil discharge screw
To Next Page
Loading...
