7
Description
Delayed motor cut-out
Frequent, work-necessitated switching on and off of motors on
machines of this size puts a heavy load on the power network and
causes increased wear on internal electrical parts. Therefore the
motor of the new KRANZLE device only switches off 30 seconds after closing the
gun and then goes to stand still. By opening the gun, the device is started again.
Safety cut-out
If the device is accidentally not turned off after use or the pistol is not used for 20
minutes, the device automatically goes into the safety state via deactivating. By
operating the main switch again, the device is activated again.
When running your high pressure cleaner with hot water of 60° C
raised temperatures occur. Do not touch the machine without
safety gloves!
CAUTION !
Never suck in liquid containing solvents such as paint thinners, petrol,
oil or similar liquid matter. Pay attention to the instructions of
the manufacturers of the cleaning agents. The seals in the
machine are not resistant to solvents! The spray of solvents is inam-
mable, explosive and poisonous.
CAUTION !
Neither set up and operate the machine in rooms where there is a risk
of re or explosion nor put it into puddles. Do not use the machine under
water. The device must not stand in the spray area of the high pressure jet.
Replacements and inspection work should only be performed by quali-
ed persons when the machine is disconnected from the
power supply, i.e. the plug pulled out from the electrical
socket.
Setting up
Location
To Next Page
Loading...
Need help?
General
