14
Care and Maintenance
Care and maintenance is required to keep the machine in good working order, and to
allow you to enjoy the machine for as long as possible..
IMPORTANT!!!
Always remove the plug before working on the machine!
What to do!
- weekly, or after approx 40 hours of operation
* Check the oil lebel on the housing of the high pressure pump
If the oil level is too low, top up with oil until the sight glass is full.
Change the oil if it has a grey or whitish appearance. The oil should be
disposed of responsibly.
* Check the filter in front of the float valve in the water tank and the fuel filter
in front of the magnetic valve. Clean the filters if necessary..
- Yearly, or after approx 500 hours of operation
* Desulphurise and clean the heating element.
* Check the oil burner and ignition system
Clean the oil nozzle, oil filter, magnetic valves and filter, clean and adjust
the ignition transformer, ignition cable and ignition electrodes and replace
defective parts
Care and Maintenance
Adjusting ignition electrodes
To Next Page
Loading...
Need help?
General
