How to fix aerator drips or inconsistent water flow in my Kraus Plumbing Product?
If the aerator of your Kraus Plumbing Product drips or the water flow is inconsistent, it could be that the aerator is dirty or not seated properly. Use an aerator wrench to unscrew the aerator and clean out any debris.
What to do if there is leakage under the Bonnet nut of my Kraus Plumbing Product?
If you find leakage under the bonnet nut of your Kraus Plumbing Product, remove the index and tighten the bonnet nut with an adjustable wrench.
What to do if hose connectors of my Kraus Plumbing Product are dirty?
To address dirty hose connectors in your Kraus Plumbing Product, clean the water valve and unscrew the hose connectors from the supply lines.
What to do if my Kraus Arlo KVF-1200ORB water will not shut off completely?
If your Kraus Plumbing Product isn't shutting off completely, the cartridge may need adjustment or replacement. First, remove the index. Then, tighten the bonnet nut using an adjustable wrench. Re-install the cartridge.
Why is there leaking from the sink drain at the base of my Kraus Plumbing Product sink?
If you notice leaking from the sink drain at the base of your Kraus Plumbing Product sink, it might be due to a rough or irregular sink surface. To fix this, apply additional silicone sealant to the beveled edge of the sink and then test for any leaks.
General| Finish | Oil Rubbed Bronze |
|---|---|
| Material | Brass |
| Mounting | Single Hole |
| Number of Handles | 1 |
| Flow Rate | 1.2 GPM |
| Handle Style | Lever |
| Valve Type | Ceramic Disc |
| Mounting Type | Single Hole |
| WaterSense Certified | Yes |
| ADA Compliant | Yes |
| Lifetime Warranty | Yes |
| Product Type | Bathroom Faucet |
| Faucet Type | Vessel |
| Installation Type | Deck Mounted |
| Installation Hole | 1.375 inches |
Advice for installers regarding water supply before faucet installation.
Instructions for removing existing faucet components like washers and nuts.
Detailed procedure for mounting the new faucet onto the countertop.
Guide for connecting the faucet's water supply lines to the angle stops.
Instructions on how to assemble and install the pop-up drain mechanism.
Procedure for flushing the faucet to remove debris after installation.
Addresses common issues like leakage, aerator problems, and low water flow with causes and actions.
Provides instructions on how to clean and maintain the faucet to keep it in good condition.
Details limitations and exclusions for the faucet warranty coverage.
Outlines the warranty terms for industrial, commercial, and business use.
Provides contact details for homeowners, contractors, and partners for service inquiries.
To Next Page