7
Step 5. Making the waterline connections
Step 6. Flushing and checking for leaks
Thread the nut (1) on the supply line onto
the outlet of the water supply valve and
tighten with a wrench. Do not overtighten.
Pull the hose assembly out of the spout
and remove the spray head by unscrewing
it from the hose in a counterclockwise
direction. Be sure to hold the end of the
hose down into the sink and turn the
faucet on to the warm position where it
mixes hot and cold water. Flush the water
lines for one minute. This flushes away any
debris that could cause damage to internal
parts. Check for leaks. Re-tighten any
connections if necessary, but do not
overtighten. Reinstall the spray head by
hand tightening it back onto the spray
hose. After installation is completed, turn
on the hot and cold water supplies. Check
for leaks.
Step 4. Attach the spray hose and counterweight
Connect the spray hose (F) to the supply
hose (D). Tighten with wrench until snug.
Install the weight (E) on the indicated mark
on the spray hose (F).
1
To Next Page
Loading...
Need help?
General
