Attach waterlines to angle stops and tighten until snug. Turn on angles stops and check for leaks (DO NOT TURN
FAUCET ON)
NOTE please make sure filter washers are installed before connecting to the main valve.
Connect the filter water inlet pipe (b) into the end of the filtration manifold (not including).
Pull moderately to ensure the connection has been made.
NOTE: 3/8″ typical connection attached. 1/4″ connector/reducer included in the box for A-typical connections.
Step 5: Flushing and checking for leaks
Unfiltered Water Function
Pull the hose assembly out of the spout and remove the spray head (A) by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end of the hose down into the sink and turn the faucet to the warm
position where it mixes hot and cold water.
Pulling the handle towards yourself will turn the water too hot. Pushing the handle away from yourself will turn the water
to cold.
Flush the water lines for one minute. This flushes away any debris that could cause damage to internal parts. Check for
leaks.
Re-tighten any connections if necessary, but do not overtighten. Reinstall the spray head (A) by hand tightening it back
onto the spray hose in a clockwise direction.
To Next Page
Loading...
Need help?
General
