Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective
steps:
PROBLEM C AUS E A CTI ON
Leakage under the
handle
Bonnet nut (7) has
come loose
Remove the index (11).
Loosen set screw (10) with hex wrench (21). Remove
the handle (9). Unscrew cap (8) (by
hand only). Tighten bonnet nut (7) with an adjustable
wrench
The aerator has an
irregular or reduced
water flow
The aerator is dirty or
mis-fitted
Remove the aerator and check for debris.
Ensure that the rubber washer is properly installed.
Water will not shut off
completely
The cartridge may need to
be adjusted or replaced
Hot Water Cold Water Remove the index (11).
Loosen set screw (10) with hex wrench (21). Remove
the handle (9).
Unscrew cap (8) (by
hand only).
Tighten bonnet nut (7) with an adjustable wrench.
Remove the cartridge (6).
Check for cracks
There is leaking from the
sink drain at the base of
the sink.
The sink has a rough or
irregular surface.
Apply additional silicone sealant to the beveled side of
the drain flange. Retighten
and test for leaks
Close There is a low flow of
water.
The filter washer in the
The hose connectors are dirty.
Push Turn off the water supply at the water valve and
unscrew the hose connectors from the water supply
lines. Clean the filter washer in the water lines with hot
water, removing any debris or calcium build-up
Care & Maintenance
*To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. .Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3. Do not use a cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
Codes/Standards Applicable:
To Next Page
Loading...
Need help?
General
