Need help?Do you have a question about the Kraus Kore KWT310-33 and is the answer not in the manual?
General| Material | Stainless Steel |
|---|---|
| Sink Material | Stainless Steel |
| Sink Gauge | 16 Gauge |
| Sink Configuration | Single Bowl |
| Minimum Cabinet Size | 36 inches |
| Installation Type | Undermount |
| Finish | Stainless Steel |
| Sound Dampening | Yes |
| Drain Placement | Rear |
| Handle Type | Lever |
| Flow Rate | 1.8 gpm |
| Product Type | Kitchen Sink |
| Outer Sink Dimensions | 33 x 22 inches |
| Hole Count | 1 |
Details on carefully cutting the countertop opening along the traced line with an appropriate saw.
Instructions for attaching mounting hardware to the prongs on the underside of the sink rim.
Guides on cleaning, drying, and applying silicone-based sealant to the sink's edge before placement.
Instructions for inserting the sink, aligning it, tightening screws, and removing excess sealant.
Connects drain, trap, and water supply; runs water to check for leaks and verify certifications.
Details on cutting the countertop opening following the traced line for undermount sinks.
Instructions for aligning the sink and deciding mounting bracket locations, noting spacing requirements.
Guides on drilling 3/8" diameter x 1/2" deep holes in the countertop for mounting anchors.
Instructions for inserting anchors into drilled holes and tapping them flush with a hammer.
Applying sealant around the sink rim and pressing it firmly into the countertop cutout.
To Next Page
