Prior to Installation
•
Make sure that cold and hot water lines are turned o
• Wrap all threaded connections with Teon tape. Always wrap in a clockwise
direction
• Cover your drain to avoid losing parts
• Do not disassemble the main faucet body, as it has been installed &
commissioned correctly & precisely before delivery from the factory
• To keep the faucet from jamming, ush the water pipe before installation
• Using condition: Working pressure at 0.05-1.0MPa (including cold & hot
water pressure) with applicable water temperature: 4C-90C
• After installation, make sure every joint is safely sealed and that there is no
leaking
• Make sure to correct the hot/cold inlet pipe correctly: if facing faucet, hot
water pipe connects on the left and cold water pipe connects on the right
To Next Page
Loading...
