Kremlin-Rexson PMP 150 - Spray Gun

KREMLIN REXSON - 1 - N° : 578.060.110-UK-1309
CAUTION :
Before any actio n on the pump, shut off the compressed air supply and
depressurize the system.
 SPRAY GUN
Comply with the usual instruction of the spray gun s ervicing (refer to spray gun manual).
 PUMP
Guards (air motor cover, coupling shields, housings…) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
Make sure that the suction strainer is clean and in good condition.
Flush the pump as often as necessary, specially when spraying pigment-filled material.
Whatever the case, when stopping the pump always leave it filled up with :
For a short duration shutdown, if the flushing has not been carried out, leave the
pump filled up with material.
For a long duration shutdown, after flushing the pump, leave it filled up with clean
solvent.