KREMLIN REXSON Page 3 Manual : 573.191.112
Spraying of some materials may result in hazardous working conditions. To protect the operator,
respirator mask, hand cream and glasses are required (Refer to chapter "Safety equipment" of
KREMLIN selection guide).
EQUIPMENT REQUIREMENTS
The operating pressure of these equipments is particularly high. Consequently, some precautions must
be taken in order to prevent from accidents and from unsafe working conditions.
Never exceed the components maximum working pressure of the equipment.
HOSES
Do not use hoses with a maximum burst-proof pressure less than four times the maximum service
pressure of the pump (see data sheet).
Be certain hoses are not crimped, leaking and not unrolled.
Be certain hoses are in good conditions and showing no evidence of damage.
Use only air hose with static conductor to connect the pump with the spray gun.
All fittings must be tight and in good condition.
PUMP
Ground the equipment (use the connection on the pump).
Do not use any product or solvent incompatible with the pump components.
Use the appropriate solvent for the material being sprayed to increase the equipment working life.
GUN
Never wipe the end of the tip with the fingers.
Always depressurize air and fluid hoses before carrying out any servicing on the gun.
Never point the spray gun at anyone or at any part of the body.
CYCLOMIX
TM
MICRO
Do not install the machine in an explosive area. It shall be in a safe area (non explosive
area).
The display unit must be moved 1 m / 3.3 ft away from the fluid module and not be installed
above that one.
Connect the control box to t he mains supply fitte d with a ground.
The fluid module is fitted w ith a ground. Connect the ground cable to earth.
Do not use any product or solvent incompatible with the machine components.
Use the appropriate solvent for the material being sprayed to increase the equipment
working life.
Wear protective glasses to protect the operator from possible discharges during the
handling of the CYCLOMIX
TM
MICRO machine test valves.
Do not use electrostatic spraying for water-based paints with a resistivity lower than 5 M
Never modify these equipments.
Check them daily, keep them in a good condition and replace the worn parts only with KREMLIN
parts.
Before cleaning or removing components of the equipment, it is compulsory :
1 - to stop the air supply,
2 - to open the gun fluid circuit to depressurize the hoses,
3 - to shut off the machine electrical supply,
4 - to open the drain valves.
To Next Page
Loading...