Owner’s manual
23
EN
PROGRAMMING TV CONTROL BUTTONS
1. Place the tuner remote and the TV remote towards each other, at around 4 cm.
2. Press and hold the SET button, until red LED glows stronger.
3. On the tuner remote, press one of the programmable buttons (placed in TV CONTROL
frame)
4. Press the corresponding button on the TV remote a couple of times.
5. After successful paring the red LED will flash twice.
6. Press the SET button to exit pairing mode.
7. The function is assigned to the button. If the button doesn't work, try repeating steps
above.
Antenna
TV
Power supply
HDMI cable
SCART cable
CONNECTING TO THE TV
» To get standard resolution, connect the device to the TV with SCART cable.
» To get high resolution, connect the device to the TV with HDMI cable.
To Next Page
Loading...
Need help?
General