Owner’s manual
24
EN
INSTALLATION OF BATTERIES
1. Open the battery compartment.
2. Insert 2x AAA batteries with correct polarization
(+/-).
3. Close the battery compartment.
Notes:
Do not mix the batteries.
Remove the batteries if the remote control is not
going to be used for an extended period of time.
Do not place the remote control under the direct
sunlight or near sources of excessive heat.
Point the remote control to the unit no more than
8 meters from the remote control sensor and
within 30° horizontally and 30° vertically of the
front of the unit.
OPERATION
1. Press the MENU button to enter main menu screen.
2. Use navigation buttons to navigate the menu and adjust the settings.
3. Press the MENU button to return to the previous menu or press the EXIT button to
quit the menu screen.
QUICK INSTALLATION
If the receiver is being powered on for the first time or factory settings were restored, the
welcome screen will appear on the TV screen.
» Region: Select a country.
» Language: Select language.
» Display Mode: Select a screen resolution.
» Aspect Mode: Select aspect ratio of the screen.
» OK: Press OK to start automatic channel scan.
INSTALLATION
» Auto Channels Scan: Automatic searching and saving available TV channels.
» Manual Channels Scan: Manual searching for TV channels. You can search the
channel by number or frequency. When you choose the desired options, press
Search to start searching.
» LCN (Logical Channel Number): Choose this option, if you want to sort the channels
according to their logical channel number.
To Next Page
Loading...
Need help?
General