Owner’s manual
27
EN
» Digital Audio Output: Available options: BS Out or LPCM Out. The default value is
LPCM Out.
Display settings:
» Brightness (default value is 50)
» Contrast (default value is 50)
» Saturation (default value is 50)
» Hue (default value is 50)
» Sharpness (default value is 5)
Local time setting
» Region: Select your country.
» GMT Usage: Set to "By Region" if you want to use GMT and set the time automatically.
Set to "User Define” if you want to set the time zone manually, or set to "Off", if you
want to set the date and time manually. The default value is "By Region".
» GMT Offset: Set the time zone (only if "GMT Usage" is set to "User Define").
» Date: Set the date (only if "GMT Usage" is set to "Off").
» Time: Set the time (only if "GMT Usage is set to "Off").
Timer Setting
» Timer Mode: Set the time interval: Once, Daily or Off.
» Timer Service: When it is set to PVR, the receiver will switch to the preset channel, at
preset date
» and time and start recording the program. When is set to Channel, the receiver will
switch to the preset channel at preset date and time.
» Wake up channel: Set the channel.
» Wake up date: Set the date.
» On Time: Set the start time.
» Duration: Set the duration of displaying or recording a channel.
Note: It is also possible to set the Timer from EPG menu (see EPG section).
Parental lock (Some firmware versions do not support this function)
» Menu Lock: When this is enabled, the access to channel edition and searching menu,
will be protected by a password. Default value is Off.
» Rating Lock: Set the age.
» New Password: Enter new password.
» Confirm Password: Confirm the new password.
Note: Default Password is 0000. In case of forgetting set password, input code 1006 to
access the parental lock menu.
To Next Page
Loading...
Need help?
General