16
Owner’s manual
EN
BACKUP BATTERIES INSTALLATION
In case of the device being disconnected from power supply socket or a power
failure, clock and alarm settings will be retained if the backup batteries have been
installed (Bluetooth function, radio and backlight is not available).
To install the batteries follow the below instructions:
1. Push and slide out the battery compartment cover at the bottom of the device.
2. Insert 2x AA batteries (not included) with correct polarization.
3. Replace the battery compartment cover and slide it right so that it locks in place.
MOUNTING THE DEVICE
1. ON THE FLAT SURFACE
There is a foldable stand at the bottom of the device. Fold out the stand and place
the device on a at and stable surface making sure that the power supply socket is
nearby. By placing the device on its stand, you provide proper ventilation and good
quality of sound.
2. UNDER THE CABINET
Notes:
• Prior to installation, make sure if the location you want to mount the unit is rm
enough to hold its weight and safe.
• Do not install the device above the heat sources such as hot plate or stove.
• To reduce the risk of danger, consult the technician if the location where you
want to mount the device is safe and rm enough to hold its weight.
• Use only the included accessories to mount the device.
• Make sure the power supply socket is nearby the mounting location.
• Connect the device to power supply when the installation is nished.
• When mounting is nished, make sure the device has been properly and securely
attached. It should be checked at regular intervals if the screws have loosened
and are securely tightened.
Follow the below instructions to mount the device under the kitchen cabinet:
1. Remove the mounting plate by sliding it back and out of the device.
2. Apply the plate to the bottom of the cabinet and mark the drilling holes. Drill the
holes and mount the plate with the shorter screws included.
* To lower the mounting height, use the spacers and longer screws included.
Place the spacer with the narrower opening on the hole on the top of the
mounting plate, then pass the longer screw through the hole underneath the
plate and screw the plate to the bottom of the cabinet.
3. Make sure that the mounting plate has been securely attached.
4. Slide the device on the plate and check if the whole construction is secure.
To Next Page
Loading...
Need help?
General
